AirLive WN-151ARM Manuel d'utilisateur télécharger pdf (Page 22)

AirLive WN-151ARM User’s Manual

Using your Web Browser

To establish a connection from your computer to the WN-151ARM:

1. After installing the WN-151ARM in your LAN, start your computer. If your computer is already running,

restart it.

2. Start your WEB browser.

3. In the Address box, enter "HTTP://" and the IP Address of the WN-151ARM, as in this example, which

uses the WN-151ARM's default IP Address:

http://192.168.1.254

4. When prompted for the User name and Password, enter values as follows:

• User name admin

• Password airlive

Note

If the WN-151ARM does not respond, check the following:

• The device is properly installed, LAN connection is OK, and it is powered ON. You can test the connection

by using the "Ping" command:

• Open the MS-DOS window or command prompt window.

• Enter the command:

ping 192.168.1.254

if there’s no respond, either the connection is not working, or your computer’s IP address is not

compatible with the WN-151ARM's IP Address. (See next item.)

• If your computer is using a fixed IP Address, its IP Address must be within the range 192.168.1.1 to

192.168.1.253 to be compatible with the WN-151ARM's default IP Address of 192.168.1.254. Also, the

Network Mask must be set to 255.255.255.0.

• Ensure that your computer and the WN-151ARM are on the same network segment.

• For the first time, please make sure that you are using the wired LAN interface to configure the setting.

The Wireless interface configuration can only be used after the establishment of the wireless setting.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 118 119

Pas de commentaire

AirLive WN-151ARM Manuel d'utilisateur Page 22