Traffic Control QoS Guide AirLive WL-5460AP/ WL-5470AP E11 Firmware What is Traffic Control QoS? Traffic Control is a great tool to control the band
What is the Output Rate? The “Output Rate” is the data speed out of an interface. There are 3 types Output Rate supported by the AP 1. LAN Output
Configure the Traffic Control QoS From the Mode Setting page, please choose the “Traffic Control(QoS)” on the bottom of the list. Once you click on
A. Interface Control Settings: In the Interface Control Settings, the AP only controls the total bandwidth limit of an interface. For example, if
Please follow the step below to create a new policy “VIP” 1. Enter “VIP” for the “PolicyName” 2. Enter “512” for the “LAN Out Rate” 3. Enter “1024”
* If you want to control the traffic flow between the IPs in the same interface, please make sure both IPs are configured for the IP Traffic Control.
Application Example Example1: AP Mode Traffic Control In this example, the AP is installed outdoor to provide Internet service. There are 2 differ
3. Please enable the “MAC Control” 4. Please fill in the 2 entries as shown on the graphic below 5. Reboot the AP Example2: Client Mode Traf
Step-by-Step Configuration 1. Please enable the “Interface Traffic Control” 2. Enter “1024” in the “LAN Output Rate” field 3. Enter “128” in the “
Commentaires sur ces manuels